4
www.aeg.com
4. CONTROLS
Button Function
Led
L
Turns the lights on/off at maximum strength.
-
T1
Turns the motor on/off at speed one.
Fixed.
T2
Turns the Motor on at speed two.
Press and hold the button for approximately 3 seconds,
with all the loads turned off (Motor and Lights), to turn the
Activated Charcoal Filter alarm on. The relevant LED flashes
twice to confirm.
To turn the alarm off, press the button again and hold for at
least 3 seconds. The relevant LED flashes once.
Fixed.
T3
Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with
all the loads turned off (Motor and Lights), to perform a reset.
The LED S1 flashes three times.
Fixed.
T4
Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 10 minutes. At the end of this
time, the system returns automatically to the speed that was
set before. If it is activated with the motor turned off, the hood
will switch to OFF at the end of the time.
Press and hold for 3 seconds to enable the remote control,
indicated by the LED flashing twice.
Press and hold for 3 seconds to disable the remote control,
indicated by the LED flashing just once.
Fixed.
S1
Signals the Metal Grease Filter saturation alarm, indicating that
it is necessary to wash the filters. The alarm is triggered after
the Hood has been in operation for 100 working hours. (Reset
see the parag. Maintenance).
Fixed.
When this is activated, it signals the Activated Charcoal Filter
saturation alarm, indicating that the filter must be changed;
the Metal Grease Filters must also be washed. The Activated
Charcoal Filter saturation alarm comes into operation after the
Hood has been working for 200 hours. (Activation and Reset
see the parag. Maintenance)
Flashing.
