4
www.aeg.com
4. CONTROLS
5. LIGHTING
Button Function
Display
A
Turns the suction motor on and off at speed one.
Displays the set speed
Press and hold the button for approximately 5 seconds, with all
the loads turned off (Motor and Lights), to turn the Remote Control
On and Off.
IR+Dot (2 flashes)–Alarm On.
IR+Dot (1 flash)–Alarm Off.
B
Decreases the working speed.
Displays the set speed
C
Increases the working speed.
Displays the set speed
D
Activates intensive speed from any other speed, including
motor off. This speed is set to operate for 5 minutes, after
which the system returns to the speed that was set before.
Suitable to deal with maximum levels of cooking fumes.
Displays HI and the time remaining
once every second.
When the filters alarm is triggered, the alarm can be reset
by pressing and holding this button for approximately 3
seconds. These indications are only visible when the motor
is turned off.
F indicates the need to wash the
metal grease filters. The alarm is
triggered after the Hood has been in
operation for 100 working hours.
C indicates the need to change the
activated charcoal filters, and also to
wash the metal grease filters. The
alarm is triggered after the Hood has
been in operation for 200 working
hours.
E
Delay function
Activates automatic switch-off with a 20’ delay. Suitable to
complete elimination of residual odours. Can be activated
from any position, and is disabled by pressing the button or
turning the motor off.
Displays the operating speed and the
dot at the bottom right flashes alterna
-
tely with the remaining time.
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to turn the
Activated Charcoal Filter alarm On and Off.
- C flashes twice - A.C. Filter alarm
Activated.
- C flashes once - A.C. Filter alarm
Deactivated
F
Turns the lighting system on and off at maximum intensity.
Summary of Contents for X79263MK10
Page 95: ......
