www.aeg.com
4
Attention!
Also make sure that the
reset key is pressed.
Warning!
Specialised personnel must
carry out the installation.
The hood must be connected to the mains
supply by qualified and trained technicians.
When installing the product, it is
recommended to keep a minimum distance
of 400mm between the worktop and any
components laid on top of the hood.
This is to let the suction panel move
upwards (opening) and downwards
(closing) without any obstacles, and to
facilitate access to the hood controls on the
panel.
WARNING:
Put the metal box contain-
ing the electronic components at a
distance not shorter than 65 cm from
the gas hob or 65 cm from the hood
suction point.
RECOMMENDATION:
We recommend
you to install the metal box containing the
electronic components at a distance of at
least 10 cm from the ground and sufficiently
from all the sources of heat (e.g.: side of an
oven or hob).
