1. Remove the packaging materials and strings
Remove all packaging materials and strings for transport.
2. Count refrigerator accessories accompanied
Check the articles inside the refrigerator against
the packing list; if any difference, contact the
after-sale service.
3. Placing conditions
Choose the appropriate distance according
to the space requirement.
4. Adjust the leveling leg
Rotate the leveling legs with a wrench in
clockwise to extend them out and secure them
onto the ground. This is to make sure the
refrigerator does not move during operation.
5. Standing
Do not switch on the power after the refrigerator is placed, leveled and cleaned. Switch on the
power after it is put on standing for more than 24h, to ensure normal performance of refrigerator.
13
Preparation before use
Leveling leg
Downward
upward
8
1.Microprocessor temperature controller
Adjust the cabinet temperature easily by the micropressor temperature controller in control panel
installed on the top of the refrigerator. Don’t do any adjustment in the first 30 mins when you first
power the refrigerator.
LED displays the cabinet temperature.
Application method
Factory pre-set to 5
℃
. Set cabinet temperature
：
Press “Set” button and loosen quikly, LED
dispaly the pre-set temperature and flash.
Adjust the cabinet temperature with the buttons “+” or “-” and increment 1
℃
when the temperature
flash. Automatically quit the system after 10 seconds no operation and display the cabinet
temperature again(no flash). The cabinet temperature will reach pre-set temperature after a while.
High and low temperature alarms:
The alarms are activated when the cabinet temperature is warmer than the high alarm temperature
or lower than the low temperature. Press the “Alarm” button to end the buzzer, the flashing light
continues until the cabinet temperature recovers to the normal operating range.
4.Temperature adjustment: See fig #1
The maximum tilt angle of the refrigerator shall
be no more than 45° during the course of
movement.
Transportation and relocation requirement:
clamp truck or forklift truck.
2. Unlock operation instructions
3. Password setting
If there is no operation in 20s,the keys for temperature setting ¶meter setting & high/low
temperature setting will be locked,the keys for alarm & light & highest/lowest temperature
checking & high/low temperature alarm checking will still be available.Unlock:press “+”, the
display screen blinking displays "01",then press “+”or “-” to choose the password,then press "Set"
to unlock.Once unlock successfully,the buzzer beeps once and the display screen displays the
temperature normally.If the password is wrong,the display screen will flicker and it will quit the
system automatically if there is no operation in 5s.
The default unlock password is “06”.After unlock,press “Set” and “Alarm” at the same time for
5s,the display screen displays "06",then press “+” and “-”to set the password.Press“Set” to save
the setting.If there is no operation in 5s,password setting will be saved automatically. The pass-
word could be selected from 05
、
06
、
07……29
、
30.
When setting the parameters and high/low temperature alarm value,it will quit the system auto-
matically if there is no operation in 10s and display the inner temperature again.
