User Instructions
Doc ID:
PL 0004
Effective Date:
04/20/21
Revision:
0
.
Page 2
FITTING INSTRUCTIONS
Following instructions must be followed each time respirator is worn.
Aegle PPE 1 LLC
12227A FM 529 Rd
Houston, TX 77041
+1-713-364-2363
This respirator is approved only in the following configuration:
TC-
Protection
1
Respirator
Cautions and Limitations
2
F100
84A-9353
N95
X
ABCJMNOP
1.
PROTECTION
2.
CAUTIONS AND LIMITATIONS
A. Not for use in atmospheres containing less than 19.5 percent oxygen.
B. Not for use in atmospheres immediately dangerous to life or health.
C. Do not exceed maximum use concentrations established by regulatory standards.
J. Failure to properly use and maintain this product could result in injury or death.
M. All approved respirators shall be selected, fitted, used, and maintained in accordance with MSHA,
OSHA, and other applicable regulations.
N. Never substitute, modify, add, or omit parts. Use only exact replacement parts in the configuration
as specified by the manufacturer.
O. Refer to user’s instructions, and/or maintenance manuals for information on use and maintenance
of these respirators.
P. NIOSH does not evaluate respirators for use as surgical respirators.
N95-Particulate Filter (95% filter efficiency level) effective against particulate aerosols
free of oil; time use restrictions may apply.
Step 1:
Place the respirator in the palm of your hand with the nose clip closest to your fingers
and the respirator opening facing you. Starting with the lower headband first, pull
each headband up and over your hand, one at a time.
Step 2:
Position the respirator on your face with the bottom of the respirator under your chin.
Pull the bottom headband over your head and bring it around your neck, below your
ears. Then, pull the top strap up and rest it high at the top of your head.
Step 3:
Place your fingertips from both hands at the top of the metal nosepiece. Using two
hands, mold the nose area to the shape of your nose by pushing inward while moving
your fingertips down both sides of the nosepiece.
WARNING:
Pinching the nosepiece
using one hand may result in an improper fit and less effective respirator performance.
Step 4:
Perform a respirator-to-face seal check before each wearing by placing both hands
completely over the respirator, careful as to not disturb its position, then exhale. If air
leaks around the nose, re-adjust the noseclip as described in step 3. If air leaks at the
edges around your face, work the straps back along the sides of your head.
WARNING:
If you CANNOT achieve a proper seal, DO NOT enter a contaminated area.
