f. Install the supplied breather hose as shown.
Secure both ends with supplied ¾” hose clamps.
g. Attach the bracket on the upper pipe to the engine
using the supplied 6mm bolt and washer. Place the
pipe’s tab behind the stock plastic tab. Attach the
MAF sensor assembly to the intake pipe as shown.
h. Plug the wiring harness into the MAF sensor and
attach the lower intake pipe to MAF sensor using the
provided silicone hose and two hose clamps.
i. Install rubber mount into frame and attach the lower
intake
pipe’s support bracket as shown. Secure with
a lock nut and fender washer but do not completely
tighten the lock nut. See the diagram below for
proper installation of the rubber mount.
j. Proper installation of the rubber mount.
