8
n)
Attach rubber gasket to the top edge of the heat
shield.
m)
Attach filter and secure with hose clamp.
o)
Reconnect the MAF wiring harness to the MAF
sensor in the pipe.
q)
Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are tight.
r)
Start vehicle and check for proper operation of all the components that were removed.
s)
Make sure the intake pipe does not contact the heat shield during start up or while the engine is running. If
this happens, adjust the position of the pipe.
For Technical Inquiries
E-Mail Us At
tech@aempower.com