KIT CONTENTS
1 x 35-2500 AQ1 DATA LOGGER MODULE W/ 2GB SD CARD
1 x DUST COVER
4 x MOUNTING SCREW
4 x HEX NUT
1 x INSTRUCTION MANUAL
1 x USB CABLE
INSTALLATION TIPS
1. Read through the entire manual and instructions before beginning the
installation.
2. Disconnect the negative battery cable(s) before beginning any work.
3. Maintain a clean and neat work area through out the installation.
4. When raising or working under a vehicle, use properly rated stands/jacks.
5. Make sure all connectors are fully seated and inserted.
6. Make sure all components and cables are routed and installed away from any
direct heat sources or sharp objects.
TABLE OF CONTENTS
Installation
2
Using the AQ1 Data Logger 7
Connector Pinout
17
Specifications
19
Notes
19
Recommended Parts
21
Replacement Parts
21
Warranty
21
Drill Template
22
INSTALLATION
MOUNTING THE AQ1 DATA LOGGER MODULE
Find a suitable mounting location for the AQ1 Data Logger module that is shielded from
the environment (water, dirt, dust, etc) and away from any direct heat sources. The
AQ1 Data Logger comes with a flexible dust cover, but is not a sealed module.
Submerging the module or exposing the module to a direct source of moisture may
cause damage. The dust cover must be used if the module is mounted outside of a
sealed cab. The AQ1 Data Logger module must be properly oriented in order for the
accelerometer to give accurate data. A few of the more common mounting orientations
are shown below in Figure 1. A complete list is available in the software.
