BA 418-12 * 1.0 * 418_12_5_Bedienung.fm
5-91
Operation 5
Working with a standard bucket
NOTICE
In order to minimize the risk of damage to machine and environment, push
and pull material only with the telescopic boom completely retracted!
►
Fully retract the telescopic boom.
►
Material may only be picked up with the bucket at slow speed (below
3 km/h (1.8 mph)) and only with a fully retracted telescopic boom!
►
At greater heights with an extended telescopic boom, drive into the
material if the speed is below 1 km/h (0.62 mph) and the material is
mainly picked up with the work hydraulics!
Failure to observe the instructions specified above can cause serious
damage to the machine. The manufacturer does not give any warranty for
any such damage.
Machine travel with the bucket fully tilted out
NOTICE
In order to avoid damage to the tires, do not perform machine travel with
the bucket fully tilted out!
►
Tilt in the bucket and lower it to transport position
Loading loose material
1. Align the blade parallel with the ground.
2. Lower the loader unit to the ground. To do this: push the joystick
forward
C
.
3. Drive forward into the material.
When the diesel engine speed is reduced due to too much material:
4. Raise the loader unit a little. To do this: pull the joystick backward
D
.
Fig. 273
Fig. 274
Fig. 275
B
D
C
A
2.
4.
3.
1.
Summary of Contents for 418-12
