5-94
BA 418-12 * 1.0 * 418_12_5_Bedienung.fm
5 Operation
Removing material/digging in hard soil
1. Lower the bucket horizontally to the ground. To do this: push the
joystick forward
C
.
2. Adjust the digging angle flatter than for digging in soft soil. To do this:
push the joystick to the left
A
.
3. Drive forward and press the bucket downward a little as you do so. To
do this: push the joystick forward
C
a little.
Once the bucket has penetrated the soil:
4. Set the digging angle a little flatter. To do this: push the joystick to the
left
A
, so that the layer being removed is as even as possible and so
that the wheel spin is reduced.
5. Move the joystick to the left
A
and right
B
to loosen the material.
6. Proceed as for loading material hard to penetrate.
Grading
1. Lower the loader unit horizontally to the ground.
2. Reverse across the surface to be graded.
Loading vehicles
1. If possible, the truck and the working direction of the machine should
form an angle of 45°.
2. Only raise the full bucket to the tilt-out height when you are performing
machine travel in a straight line toward the truck.
If possible load material with the wind behind you to keep the dust away
from your eyes, air filters and fans.
Fig. 281
2.
3.
1.
C
A
Fig. 282
4.
B
A
Fig. 283
2.
1.
Fig. 284
Summary of Contents for 418-12
