BA 418-12 * 1.0 * 418_12_7_Wartung.fm
7-45
Maintenance 7
Adding coolant
CAUTION
Burn hazard due to hot coolant!
Hot coolant can cause burns to the skin.
►
Do not open the coolant reservoir if the engine is hot or if the cooling
system is under pressure.
►
Let the engine cool down.
►
Wear protective equipment.
Preparations
1. Park the machine on level ground.
2. Lower the telescopic boom fully.
3. Apply the parking brake.
4. Switch off the starter and remove the starting key.
5. Allow the engine/cooling system to cool down.
Adding coolant
1. Release the overpressure in the radiator. To do this: carefully unscrew
filler cap
B
and release the pressure.
2. Open filler cap
B
fully.
3. Top off the coolant to the
middle of the sight glass A
.
4. Only use authorized coolants
– see chapter 7 " Vehicle fluids and
.
5. Close filler cap
B
.
Leakage check
6. Start the diesel engine and let the engine run warm.
7. To do this, set the temperature controller of the heater to
MAX.
temperature.
➥
– see chapter 5 " Heating and ventilation" on page 5-34
.
8. After reaching the full temperature, shut off the engine and pull out the
key.
9. Check the cooling system and the heater for leaks (visual check).
➥
Have leaks immediately repaired by a qualified service center.
10.If necessary, add coolant and repeat the procedure until the coolant
level remains constant.
Fig. 394
A
B
Summary of Contents for 418-12
