7-54
BA 418-12 * 1.0 * 418_12_7_Wartung.fm
7 Maintenance
7.12 Hydraulic system
Important information on the hydraulic system
CAUTION
Burn hazard due to hot hydraulic oil!
Hot hydraulic oil can cause burns to the skin.
►
Release the residual pressure in the hydraulic system.
►
Let the engine cool down.
►
Wear protective equipment.
• Release the pressure in all lines carrying hydraulic oil prior to any
maintenance and repair work. To do this:
- Lower all hydraulically controlled attachments to the ground, stop the
engine and switch off the ignition.
- Use the parking brake to park the machine safely and to prevent it
rolling away.
- After stopping the diesel engine, move all control levers of the
hydraulic control valves several times to release the pressure.
- Secure the lift ram of the raised telescopic boom with a prop to
prevent unintentional lowering.
- Wear protective clothes during maintenance.
NOTICE
Contaminated hydraulic oil, lack of oil or wrong hydraulic oil poses a risk of
serious damage to the hydraulic system!
►
Take care to avoid dirt when working!
►
Always add hydraulic oil using the filling screen!
►
Only use authorized oils of the same type.
►
Always add hydraulic oil before the level gets too low.
►
If the hydraulic system is filled with biodegradable oil, then only use
biodegradable oil of the same type for adding oil – observe the sticker
on the hydraulic oil reservoir.
►
Have the hydraulic oil replaced by an authorized service center only.
Fig. 405
Summary of Contents for 418-12
