BA 418-12 * 1.0 * 418_12_8_Betriebsstoerung.fm
8-3
Malfunctions 8
8.2
Malfunctions of the travel drive
If an error exists, this is shown by error codes in the digital display of the
indicating instrument and by acoustic warnings.
Reading the error code
– see chapter 4 " Error memory" on page 4-45
,
“Acoustic warnings” on page 4-48
and
“Overview of error codes of drive
.
Caution!
Drive system repairs may only be performed by authorized
service centers and trained personnel.
Information
Basically, proceed as follows when the travel direction selection does not
work:
►
Press push button “Neutral position” on the joystick and select the
travel direction again.
►
If this does not start; start diesel engine again, and then select the
travel direction again.
►
If the malfunction persists, have the drive immediately checked or
repaired by an authorized service center.
►
For further possible causes, see table.
Malfunctions
Possible causes
Remedy
See
Travel direction selection
does not work after new
start
Parking brake applied – arrows
on the joystick flash
Release the parking brake
The touch button
(neutral position of the drive
system) was unintentionally
actuated when the travel direction
was selected
1
Start the diesel engine again
2
Release the parking brake
3
Select the travel direction again
The travel direction was
selected and at the same time,
the accelerator pedal was
pressed and the parking brake
released
If the diesel engine runs at idling speed:
1
Release the parking brake
2
Selecting a travel direction
3
Press the accelerator pedal
Maximum travel speed is
not reached
The drive system temperature is
below 20°C (68°F)
Heat up the drive system to over 20°C
(68°F) operating temperature
–
Drive without full output
The drive electronics has
detected an error and switches
to “Limited Mode” (extremely
limited drive output)
1
Stop the diesel engine
2
Disengage the starter
3
Put on parking brake
4
Start the diesel engine
5
Release the parking brake
6
Select the travel direction again
7
Check the drive output
8
If the problem persists, have the
drive checked by an authorized
service center
–
Summary of Contents for 418-12
