BA 418-12 * 1.0 * 418_12_8_Betriebsstoerung.fm
8-19
Malfunctions 8
Serious error
NOTICE
A severe error can lead to damage to the vehicle. In order to avoid
damage on the vehicle:
1. Retract the telescopic boom.
2. Lower the load into the transport position.
3. If possible, drive the machine out of the danger zone.
4. Stop the engine and switch off the ignition.
5. Restart the engine.
If the error is issued again:
6. Make a note of the error code of the display.
7. Stop the engine and remove the starting key.
8. Determine the cause of the error (see following table), contact
specialized workshop and have the error rectified as soon as possible.
Fig. 435
SPN
FMI
Description of severe errors for the drive electronics
516400
12
Voltage level at control unit N001, connector XE05, PIN 2 is outside the permissible range
516401
12
Sensor voltage at control unit N001, connector XE05, PIN 3 is above the permissible range
516405
12
Voltage level at signal input, control unit N001, connector XE05, PIN 10 and PIN 11 is outside
the permissible range.
516408
12
Travel speed mode signal (CAN) is faulty, implausible or is outside of the valid range.
516409
12
Voltage level at signal input, control unit N001, connector CC1, PIN 5 is outside the permissible
range.
516410
12
Voltage level at signal input, control unit N001, connector CC2, PIN 4 is outside the permissible
range.
Summary of Contents for 418-12
