49
Perform Maintenance Safely
Complete Service And Repairs Before Machine
Is Released
Tighten all bolts, fi ttings, and connections to torques
specifi ed by the manufacturer.
Install all guards, covers, and shields after servicing.
Replace or repair any damaged parts. Refi ll and
recharge pressure systems only with manufacturer
approved or recommended fl uids.
Start the engine and check for leaks. (See page 44,
Hydraulic System Hazards
.) Operate all controls to
make sure the rough terrain forklift truck is functioning
properly. Test the truck if necessary. After testing, shut
down and check the work you performed. Are there any
missing cotter pins, washers, locknuts, etc.? Recheck
all fl uid levels before releasing the loader for operation.
All parts should be inspected during repair and replaced
if worn, cracked or damaged. Excessively worn or
damaged parts can fail and cause injury or death.
Replace any damaged or illegible machine or
safety signs.
Verify
Service Work
When
Completed
50
Final Word To The User
You have just fi nished reading the AEM Rough Terrain
Forklift Truck Safety Manual. It is impossible for this
manual to cover every safety situation that you may
encounter on a daily basis. Your knowledge of these
safety precautions and your application to the basic
rules of safety will help to build good judgment in
all situations. Our objective is to help you develop,
establish and maintain good safety habits to make
operating a Rough Terrain Forklift Truck easier and
safer for you.
Summary of Contents for 418-12
