2-2
BA 418-12 * 1.0 * 418_12_2_Sicherheit.fm
2 Safety
2.2
Behavioral measures and safety instructions
Prerequisites for operation
• The vehicle has been designed and built in accordance with
state-of-the-art standards and the recognized safety regulations.
Nevertheless, its use can cause danger to the operator or other
persons, or damage to the machine.
• Store this Operator’s Manual in the place provided for this in or on the
vehicle. Immediately replace a damaged or illegible Operator’s Manual
and any supplements to it.
• The vehicle must only be operated in accordance with its designated
use and the instructions set forth in this Operator’s Manual.
• The operator and owner are obligated not to put into operation or
operate a damaged or malfunctioning vehicle.
- If a damage or malfunction occurs during operation, put the vehicle
out of operation immediately and secure it against restart.
- Have all malfunctions jeopardizing the safety of the operator or other
persons immediately repaired by an authorized service center.
• Do not put the vehicle into operation or operate it after an accident;
have it inspected for damage by an authorized service center.
- Have the seat belt replaced by an authorized service center after an
accident, even if there is no visible damage.
- Cabin and protective structures
• Remove all dirt, snow and ice from climbing aids (for example from the
handholds, footholds, handrails).
• The owner is responsible for requiring the operating and maintenance
personnel to wear protective clothing and equipment as required by the
circumstances.
Summary of Contents for 418-12
