5-104
BA 418-12 * 1.0 * 418_12_5_Bedienung.fm
5 Operation
Transporting material
WARNING
If the load is not secured, it can tip over to the back if the loader unit
is raised and/or the telescopic boom extended!
Failure to observe this can cause serious injury or death.
►
Do not transport loads with a raised loader unit.
►
Tilt in the attachment a little toward the machine; carry it as close as
possible to the ground and bear in mind the required ground clearance!
►
Unload material only at machine standstill and do not tilt back the pallet
forks to the limit.
►
In case of a bulky load: secure the load.
►
Fit the rear of the pallet forks with a protective device.
►
Install a protective screen (option) onto the cabin.
►
Use attachments with hydraulic grabs (option).
►
Ensure good visibility of the material you want to pick up and of the
work and travel range.
WARNING
The machine can tip over during machine travel or maneuvers on
slopes with a load on the pallet forks!
Failure to observe this can cause serious injury or death.
►
Lower the loader unit to the transport position.
►
If possible, travel in reverse with a load on the pallet forks.
WARNING
The vehicle can tip over in conditions of strong wind and poor
visibility with a raised loader unit and fully loaded pallet fork!
Failure to observe this can cause serious injury or death.
►
Avoid high storage positions for material which should not be exposed
to wind.
►
Stop fork lift work in conditions of strong wind and poor visibility.
Fig. 293
Wrong
Correct
Summary of Contents for 418-12
