42
Input signal
time
Fenster-Funktion
output
Low-Pegel
High-Pegel
The fields “delay ON“ and “delay OFF“ doesn’t have to be filled in necessarily. In the event of not en-
tering a time the delay amounts 0 seconds each time. In case of entering a time (e.g. 5 sec), the moni-
tored parameter has to be exceeded or to be fallen below the specified time before switching the warn-
ing channel.
Input signal
time
Beispiel Schaltverzögerung 5 Sek.
output
Low-Pegel
High-Pegel
1 2 3 4 5
1 2 3 4 5
1 2 3
5
4
1 2 3 4 5
1
3 4 5
2
1 2 3 4 5
t
EIN
t
AUS
Via the switch “inverted logic” the result of the warning channel can be inverted or negated.
Via the switch “AND/OR” the warning channel can be connected logically with a further warning chan-
nel which can be selected in the selection series “warning channel 1-8”. The switch has got 3 states
“AND” (on click), “OR” (two clicks) or “OFF” (three clicks). In case of choosing no warning channel the
switch “AND/OR” will be ignored.
The default value of the warning channels is logical-0. Is a warning channel connected to a deac-
tivated warning channel the deactivated channel has always the default value logical-0.
To avoid a circular reasoning the warning channel, which is connected via the switch „AND/OR“ to an-
other channel, will be deactivated of greyed out in the configuration field of the other warning chan-
nels.
The figure below shows a configuration example for a wind direction independent warning. In the ex-
ample the warning channel 1 is connected to the warning channel 5 via “AND”. With the selection of
the connected channel the channel 5 has been locked for the choice in all the other warning channels.
