Simple Logger
®
II (Bluetooth Edition) Series
17
3.7
Erasing Data from Memory
Erasing data from the instrument’s memory can only be performed while
in the STANDBY mode.
There are two ways to erase the memory:
Erasing the Memory using the Control Button:
1.
Press and hold the
CONTROL
button. When the ERASE (RED) LED
lights up, release the button.
This will arm the instrument for an erase
operation (when not in
record mode). While armed to erase memory,
the RED LED will blink
at a fast rate for a period of five seconds
2.
Press the
CONTROL
button for another 0.5 seconds to start the erase
operation. During the erase operation the LED will blink once every
second. Erasure takes about 1 minute to complete.
If the button is not pressed within five seconds of arming, the erase oper-
ation will automatically disarm and memory will be maintained. For this
reason, if you do not intend to erase memory, simply wait until the RED
LED stops blinking at the fast rate.
Erasing the Memory using the
Simple
Logger
II
Control Panel:
1.
Connect the instrument to the computer and launch the
Simple
Logger
II
Control
Panel.
2.
Select
Erase Memory
from the
Instrument
menu.
3.
A dialog box will appear asking to confirm the erasure of the instru-
ment’s memory. Select
Yes
to confirm or
No
to cancel the operation.
Erasing the memory will also clear any stored alarms.
