21
4.4 ENGINE OIL & FILTER CHANGE
1. Place vehicle on a level surface.
2. Clean area around drain plug at bottom of oil
pan.
3. Run engine two to three minutes until warm.
Stop engine.
4. Place a drain pan beneath oil pan and remove
drain plug from under the crankcase.
CAUTION: Oil may be hot. Do not allow
hot oil to come into contact with skin as
serious burns may result.
5. Allow oil drain completely.
6. Replace sealing washer on drain plug.
NOTE:
The sealing surfaces of the drain
plug and crankcase should be clean and free
of burrs, nicks or scratches.
7. Reinstall drain plug and torque to 14 ft. lbs.
(19Nm).
8. The oil filter is located on the right side of
the machine. Place drain pan beneath oil
filter. Using an oil filter wrench, turn filter
counterclockwise to remove.
9. Using a clean dry cloth, clean filter sealing
surface on crankcase.
10. Lubricate O-ring on new filter with a film of
engine oil. Check to make sure the O-ring is
in good condition.
11. Install new filter and turn by hand until filter
gasket contacts the sealing surface, then turn
and additional 1/2 turn.
12. Remove oil cap.
Summary of Contents for Cobra 220
Page 1: ...AEON MOTOR CO LTD SERVICE MANUAL...
Page 63: ...62...
