send a low battery alarm to the main controller.
VII. WAKE UP
Pressing and holding button for 5 seconds and then release so the NanoMote One will wake up
itself and send wake-up notification out to Z-Wave Controller. After that, it can be operated to
update
parameters, OTA, and detect battery level etc.
VIII. CHILD LOCK FUNCTION
Child Lock function. If enable the Child Lock function, the LED indicator will not be on when press
down the button. To switch on/off the Child Lock function, please press and hold the button for 10
seconds, the LED indicator will be solid on in red. Then release the button, the LED indicator will
be continuously stay in red for 2 seconds. During this 2 seconds, please click the button once, the
LED light will be blink fast in red for 2 seconds.
IX. TESTING Z-WAVE NETWORK RANGE
Press and hold the button for 15 seconds, the LED light will be solid on in purple. Then release the
button, the LED light will be stay in purple for 2 seconds, during this 2 seconds, please click the
button once, it will start to test the Z-Wave network range and LED light will blink fast in purple.
After finish the test, if the LED light is in green, it refers to strong signal; if in blue, it refers to
medium signal, and if in red, it refers to weak signal or no signal.
TIP:
This function works only when
NanoMote One
has been included into a Z-
Wave network.
X
. RESET NanoMote One
Reset procedure clears the NanoMote One’s memory, including Z-Wave network information.
To reset NanoMote One:
Press and hold the button for 20 seconds, the LED light will be solid on in red. Then release the
button, the LED light will be stay in red for 2 seconds, during this 2 seconds, please click the button
once, it will start to restore factory default. At the same time, the LED light will be solid on in
colorful for 15 seconds. Then Sending Device Reset locally notification to the controller.
!
