the associated nodes when the Button is short pressed.
2.Switch Multilevel Start Level Change
NanoMote One
will send “Switch Multilevel Start Level Change” to
the associated nodes when the Button is held down.
3.Switch Multilevel Stop Level Change
NanoMote One
will send “Switch Multilevel Stop Level Change” to
the associated nodes when the Button is released.
2. Basic Command
There is no relevant commands are available for mapping.
3. Battery Command
NanoMote One
will send battery report to the lifeline group when Button is triggered during the
sleep mode. If the battery level of the Scene Controller is less than 20%, the Scene Controller will
beep 3 times when the button is pressed.
TIP:
1. The max number of associated nodes of each groups is 5.
2. Association allows for direct transmission of control command between
devices and takes place without
the participation of the main controller.
XIII. BUTTON FUNCTION
NanoMote One offers three button action types, including short press, held down and release.
Short press allows Scene Controller sends:
Central scene notification commands to the nodes associated nodes.
Basic set command to the nodes associated nodes.
Switch multilevel set command to the associated nodes.
Press and hold (more than 2 seconds) allows NanoMote One sends:
Central scene notification command to the associated nodes.
Multilevel start level change command to the associated nodes.
Release allows NanoMote One sends:
Central scene notification command to the associated nodes.
Multilevel stop level change command to the associated nodes.
XIV. ADVANCED CONFIGURATION
NanoMote One offers a wide variety of advanced configuration settings. Below parameters can be
!
