AEQ
AM
‐
03
Self
‐
powered
Stereo
Audio
Monitor
4.2.2. L/R balance selection
The balance switcher (7) admits us to balance the signal between the left and right
channels or, if necessary, using only one of this, turning the switch anti-clockwise for the left
channel or clockwise for the right cannel.
4.2.3. Audio Input selection
The switch (8) allows us to select one of the six stereo audio inputs that the unit is
equipped with.
Remember that the input selected with this switch will also be present at the parallel
output (12 – 13), as already mentioned in Section 3.1.2
4.3.
Audio phase metering
4.3.1. General
The phase meter permits us to monitor the audio signal in phase. This can be done in
stereo or only left or right channel respectively.
4.3.2. Left channel signal presence
In the case that the equipment only disposes of a signal proceeding from left channel,
the phase meter will illuminate as shown in figure 5.
4.3.3. Right channel signal presence
In the case that the equipment only disposes of a signal proceeding from right
channel, the phase meter will illuminate as shown in figure 6.
FIGURE 5
FIGURE 6
