22
GB
23
USE OF ACCESSORIES / CARE AND
MAINTENANCE
Fixing the floor cloth onto the frame
Be careful to ensure, when changing the floor cloth,
that the floor wiper frame has cooled down, before
the cloth is removed and a new one put in place.
• Pull the floor cloth over the floor wiper frame up
to the edges.
• Then place the Velcro fasteners found on the
cloth over the frame and secure the two inner
surfaces of the cloth facing each other in place.
• If it is very cold outside, avoid cleaning panes of
glass with steam due to the risk of breakage.
Pointed spray nozzle
• The pointed spray nozzle is particularly suited
to cleaning corners where access is difficult.
Since both the temperature and steam pressure
peak just as they leave the nozzle, the closer the
nozzle is applied to the dirty area, the greater
the intensity of the cleaning performance.
• The pointed spray nozzle can either be attached
directly to the handle or also to the extension
pipe, in order to extend the reach.
Application areas:
• Cleaning of taps, drain, washbasins, WC and
radiators.
Plastic brushes
• The plastic brushes are particularly suitable for
cleaning tiles, ceramics and marble surfaces.
• The plastic brushes are screwed in directly to the
pointed spray nozzle.
• Using the pointed spray nozzle, you may
subsequently attach it to the handle or, for
added reach, also to the extension pipes.
• The plastic brushes are not designed to be used
to treat delicate surfaces.
CARE AND MAINTENANCE
Rinsing out the water heater
Deposits in the water heater mean this should be
regularly rinsed out after it has been filled 10 -15
times.
• Switch off the device, unplug from the mains
and allow the device to cool down thoroughly.
• Once the device has cooled down and the
excess steam has been released, open the
safety catch and fill the water heater with
approx. 500 ml of water.
• Subsequently, resecure the safety catch in place
and shake the device.
• Then open the safety catch and turn the device
over, to allow both the water and deposits to
run out of the water heated.
Window wiper
The window wiper is especially suitable for cleaning
large, flat surfaces, e.g. like windows, tiles, ceramics
and marble.
• The window wiper can either be attached
directly to the handle or, to lengthen the reach,
also to the extension pipes.
• Apply steam to the surfaces to be cleaned, using
the steam delivery button on the handle.
• Remove excess water after steaming and loose
dust particles with the wiping edge.
Important instructions:
• Please note carefully when cleaning panes of
glass that sudden changes in temperature could
cause the glass to smash or break up. When
cleaning the pane of glass, do not direct the
steam jet directly at the sealing joints.
• If it is cold outside, the panes of glass must,
without fail, be evenly warmed. To do so,
gently apply steam to the entire glass surface.
Temperature differences caused by uneven
heating or heating only part of the surface can
lead to the glass spontaneously shattering.
30777-English_2 .indd 22
27/2/07 9:28:48 AM
