AM Series Boilers and Water Heaters
CHAPTER 9 – OPERATION
OMM-0100_0D
AERCO International, Inc.
•
100 Oritani Dr.
•
Blauvelt, NY 10913
Page
93
of
154
GF-146
Ph.: 800-526-0288
03/28/16
CHAPTER 9:
OPERATION
9.1 General Operation
The unit is pre-set with standard parameters. However, it is possible to make a number of
changes to the parameters by means of using the “User Menu” (see Section 9.15) and
the “Installer Menu” (see Section 9.16).
During use, the part of the display labeled “N” (in Figure 9-1 shows the supply temperature (if the
boiler is supplying heat) or the indirect water heater temperature (if boiler is supplying a tank
load). The part of the display labeled “M” shows the pressure of the heating system. The
o t h e r i c o n s i n t h e d i s p l a y s h o w t h e s t a t u s o f t h e various operating parameters per
Figure 9-1.
Figure 9-1: Boiler Control Panel Functions and Indicators
