6/7
FLY629_A
Aereco S.A.
REQUIRED TOOLS
The following tools are required to disassemble the fan:
Ring spanner
Wire cutter
Cross-headed
screwdriver
Painter knife
DISSASSEMBLY MANIPULATIONS
In the aim at recycling the product, the disassembling of the different plastic parts and electronic parts
has to be done in accordance with the following steps (see section 2 to visualize the parts):
First of all, disconnect the fan power supply.
A)
Before working inside the DXR Unit, these operations have to be done :
1.
Remove the 2 filter traps
2.
Remove the 16 screws and door washers
Then unlatch the door from its hinges (If the hinges are presents)
3.
Remove all of the gate with its drain pan (Beware of spacers)
B)
Drain pan A5246
1.
Put off the 9 blind rivets of the condensate tray fastening
2.
Pull out the condensate tray from the door
(Caution: this operation will damage the foam of the door)
3.
Remove the condensate tray
4.
Remove the 2 screw connections of the condensate flow
5.
Remove the condensate tray foam
C)
Supply card CE4930
1.
Remove the 2 screws and fixing washers of the electrical cover
2.
Remove the electrical cover
3.
Remove the foam bypass
4.
Disconnect the actuator bypass B2F from the supply card
5.
Unlock the bypass actuator B2F from its base, exerting slight rotation
6.
Remove the actuator bypass B2F
7.
Disconnect the 9 wires of the supply card
8.
Disconnect the 2 cables RJ12
9.
Remove the 5 screws, washers and mounting nuts from the supply card
(Beware of spacers)
10.
Remove the supply card CE4930
