4
STEPS
1.
Remove the front cover (A).
2.
Unclip the electronic card (B) and the plastic protection (D) from the base (C).
3.
Fix the base (C) by the mean of 2 screws (not supplied). The screws and
plug must be chosen according to the type of the support.
4.
Connections : use PVC wires S minimum = 0.25 mm² for all the wires.
On the electronic card (B), connect the wires as follows:
Connectors >
V+
S1
S2 S3 S4
GND
Supply (2 wires)
12 VDC
0 V
PWM output (2 wires)
PWM n.1
PWM n.2
0-10 V output (2 wires)
10 V
0 V
∙ PWM output : 0 % = 0 ppm ; 100 % = 2 000 ppm
∙ 0 - 10 V output : 0 V = 0 ppm ; 10 V = 2 000 ppm
PWM and 0-10 V output can be use simultaneously.
5.
Clip the electronic card (B) with the plastic protection (D) inside the base (C)
6.
Put the cover (A) on the base (C)
7.
Connect the wires to the external devices (12 VDC supply and device driven
by the PWM or 0-10 V output) with >1MΩ impedence on S1 and S3
8.
Only once all the connections have been made, plug on the supply of the
system.
