3/22
TF5774_C
Aereco S.A.
INTRODUCTION
WARNINGS
BEFORE INSTALLING THE APPLIANCE, PLEASE READ THESE INSTRUCTIONS CAREFULLY.
▪
The manufacturer cannot be held liable for damage caused by installation in violation of good practice and/or contrary
to the directions given in the installation manual.
▪
This manual describes how the fan must be installed and used.
▪
The whole system must be installed by an approved professional and in compliance with the standards in force.
▪
Do not use this appliance other than for its intended purpose.
▪
After unpacking, make sure that it is not damaged. Any functional defect must be reported to your dealer.
▪
Wearing suitable gloves while handling the product is strongly recommended (some of the metal parts have sharp
edges).
Reminders of elementary safety rules:
The use of an electrical appliance requires observance of the following elementary rules:
▪
Do not touch the appliance, even if it is earthed, if your body is moist or wet (hands, feet, etc.);
▪
This system is not designed to be installed or used by persons whose intellectual and/or mental faculties are
impaired, or who lack experience and knowledge (including children), unless they have been trained and are
supervised by a person responsible for their safety during installation. To eliminate any risk of an accident, keep
them away from the appliance;
▪
The electrical installation and connection work must be done by a qualified technician, in accordance with the
manufacturer's recommendations and in a manner consistent with the characteristics of the product;
▪
Before doing any work on the appliance, unplug it or otherwise disconnect it from its power supply and make
sure that the power cannot be restored accidentally while the work is being done;
▪
Any change or replacement of a wire must be done by a qualified technician;
▪
Young children must be kept far away from the appliance in order to ensure that they do not play with it.
The following instructions must also be observed:
▪
The number of fans and their arrangement must be studied so as to ensure the proper operation of the system.
▪
In general, barring special cases, all ducts of a given stack of housing units must be equipped with one or more
fans.
