19/36
Aereco S.A.
2)
Connect each fan (electronic driving box of the fan - see installation instructions of the fan) to its
module respecting the terminals (observe the colour code):
Fan module terminal '1 ' on terminal '1' of the fan
Fan module terminal '2 ' on terminal '2' of the fan
Fan module terminal '3 ' on terminal '3' of the fan
Fan module terminal '4 ' on terminal '4' of the fan
3)
Check that the jumper pin located at the top right of the electronic
driving box of the fan is on pins '1 '& '2' "MS mode".
Electronic driving
box of the fan
Summary of Contents for VBP+
