TECHNICAL AND MAINTENANCE DOCUMENTATION
VTR-HD
3
WWW.AERECO.COM
2. FAN INSTALLATION
The VTR fans are suitable for outdoor use, in a vertical position only.
To avoid vibrations and their transmission to the building structure, the following must
be used:
- anti-vibration mounts,
- flexible connections between the fan and suction and discharge lines.
The connected ventilation duct should be equipped with an acoustic silencer with properties
specified in the installation design.
Beware of sharp edges and corners.
Disconnect the fan from the mains supply before carrying out any installation or maintenance
work.
All works inside the fan casing and connected to the power supply and fan automated
system must be carried out after the power supply has been disconnected. The installer
is responsible for the compliance with all applicable safety regulations for electrical
connections and protection against accidental contact.
Clearance must be provided around the fan, the automated system and the measuring
stub to allow for future maintenance.
The automated control system must be located in an easily accessible place.
When storing and assembling the fan, the automated control system must be protected
against water penetration.
During all works connected with the fan service one should
- use protective gloves,
- use tools intended for maintenance works.
3. FAN MODELS
ATTENTION!
Before switching on, the fan
must be connected to the ducting
network. The installation must be
performed in such a way that no
contact with moving parts of the fan
is possible. Installation may only be
carried out by qualified personnel.
Before starting the fan, check
that there are no foreign objects
blocking the impeller.
VTR-71-HD
Automated system
HD / HD.TS
Size
71
72
Fan
