8
2. Hold the 'SET' key for 3 seconds until the red light glows more
brightly.
3. Press the glowing '
' POWER key, it will flash „available‟ for 10
seconds.
4. Press the 'POWER' key on the original remote control.
5. The red light will flash 3 times and glow steadily in
acknowledgement.
6. Press 'SET' to save your new remote-control command(s).
7. Repeat to clone up to 4 TV or Display remote functions.
Installation
Select a mechanically stable and well ventilated location to place
your receiver. Connect Antenna & AV Output cables before
powering up your receiver. Connect the power supply and finally
the mains power. The receiver wil
l respond showing the word “boot”
on the front panel number display. Allow some 5 seconds for it to
start. When you see this display: