33
NRL 0280-0750 60Hz
EN
Start-up procedure
A� er having powered up the unit the control board will
carry out preliminary opera� ons before being ready
for use. This ini� al procedure takes around 60 seconds
to complete. During the ini� al loading procedure two
screens are displayed: a start-up screen and a screen to
select the system language. These screens are detailed
in the table below.
WARNING: The system language can be set on the
screen displayed at the start-up or can be modifi ed at
any � me through the appropriate screen contained
in the Installer menu.
Display on the unit
Index
Display/Parameter
C
B
Wait please
6s
A
Installer
ENTER for change
Language:
Time show mask:
English
ESC to confirm
20
A
Remaining time for software loading:
this value shows the remain-
ing time to starting the software loaded on the unit, and passing the
to system language selection
B
System language:
this parameter shows the current language set for
the system. To change the language follow the instructions shown on
the screen.
C
Remaining time to select the language:
this value shows the
remaining time to modify the language. When the time elapses the
display goes to the main screen (Main screen - General monitoring).
WARNING: It is possible to modify the system language at any
time using the appropriate screen contained in the Installer menu.
(Menu password = 0000).
WARNING: It is possible to modify the system language at any time using the appropriate screen contained in the Installer menu. (Menu password = 0000).
16.
START-UP PROCEDURE
Summary of Contents for NRL0280E
Page 2: ......
