MANUAL
EV4 MOUNTAIN BOARD
2019-03-01
VERSION 1.00
Page
16
of
21
10.3.
Charging
EV4 MOUNTAIN BOARD is supplied with a Li-Ion 36V, 13Ah battery.
In order to properly charge the batteries,
use the charger supplied with the vehicle. You will need a special 36 V charger for Li-ion batteries. It is forbidden to use a
charger other than the original charger. Using a charger other than the original charger may result in electrical damage, short
circuit, fire and personal injury. It may also cause permanent damage to the battery and the vehicle's electrical system
.
The charger must first be connected to the vehicle then to the network. Charging socket is located on the battery pack
under handle. Pull the battery handle and then plug in the charger plug
.
The charger must be disconnected from the vehicle when the vehicle is fully charged (charge will not occur after
100%). It is indicated with a green lamp on the charger. Secure the vehicle's charging socket when charging is complete. After
the charge is complete, one can start the vehicle with the key. Disconnect the charger before starting the vehicle. Do not
connect any equipment or short connectors to the charger socket. The charger for the EV4 does not charge other batteries.
It is forbidden to use a fuse of other parameters. This may cause damage to the electrical system and fire.
Diag. 10 Power button and charging socket
POWER BUTTON
CHARGING SOCKET
COVER
