SECTION 8
“AERO” Sp. z o.o.
SERVICING
AT-3 R100
Page 8-2
SEPTEMBER, 2004
AEROPLANE FLIGHT MANUAL
8.1. Introduction
This Section contains procedures for the correct control of the aeroplane
on the ground and servicing, recommended by the aeroplane
manufacturer. It also contains some requirements concerning
inspections and basic maintenance, which are to be observed in order to
maintain the performance and reliability of a new aeroplane. It is
reasonable to proceed according to a prescheduled scheme of
lubrication and maintenance, appropriate to the operating conditions and
climate.
8.2. Scheduled aeroplane inspections
The scope and the intervals of the inspection schedule are defined in the
Aeroplane Maintenance Manual. A separate inspection system may be
required for the aeroplane by the appropriate Civil Aviation Authority in
order to renew the Certificate of Airworthiness. Tasks to be carried out in
relation to scheduled inspections of engine, propeller and equipment, are
defined in the respective applicable manuals or operating and
maintenance instructions.
The owner and operator are responsible and must insure, that all
servicing and maintenance is only carried out by qualified personnel.