104
2.
Bring the module and device (or heater module) closer together to connect the sensor connection of the DX coil module.
a.
Remove the temperature sensor connection from the unit supply line (if the heater module is not available) or heating module.
If the cooling module is to be connected directly to the device,
connect the device connector and the cooling module connector
each other
(Fig. 97)
b.
If the DX cooling module is to be connected after the electrical/water heater, use the connection cable shown below to
connect the heater module connector and the cooler module connector each other. (Fig. 98)
3.
Tighten the bolt. (Fig. 99)
Fig. 97
Fig. 99
Unit supply line temperature sensor
Fig. 98
Connection cable
Summary of Contents for EVO-R
