SN
10
lo
n
g
si
d
e
Assembly
www.aerocompact.com
25
There is a screw channel for attaching the wind deflectors at the back support.
Attach the wind deflectors
to the back supports at the slotted holes
.
Tighten the screws with 15 Nm or 11 ft lb each.
Attach the clips at the overlap points
.
Installing the roof anchor
Take the number and positions of the mechanical attachments from the AEROTOOL planning doc-
uments.
Mount the angle connection to the mechanical
attachment on a rear support.
Tighten the screws with 15 Nm or 11 ft lb.
Bonding
For bonding, AEROCOMPACT provides the bonding wire clamp and the aluminium wire as accessories.
These are mounted on a base rail.
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
