SN
10
lo
n
g
si
d
e
Assembly
www.aerocompact.com
14
Preassemble the front supports
The base rails are each connected to a front support. The front row of modules starts with a short base
rail. This is followed by as many long base rails as module rows are mounted.
The base rails are mounted end-to-end. The joint is aligned at the front mark of the front support.
Place base rails and front support.
Hand tighten the screws.
Tighten the screws to 10 Nm or 7.38 ftlb with a torque wrench.
Installing the back support
Determine the distance between back support
and front support according to the table.
Make a gauge for dimension B.
Module (A)
950
960
970
980
990
1000
1010
1020
1030
1040
1050
Distance (B)
847
857
867
876
886
896
906
916
926
935
945
Module (A)
1060
1070
1080
1090
1100
1110
1120
1130
1140
1150
Distance (B)
957
967
977
987
997
1008
1017
1028
1038
1048
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
