SN
10
lo
n
g
si
d
e
Assembly
www.aerocompact.com
15
Place the back support on the base rail.
Hand tighten the screws.
Tighten the screws to 10 Nm or 7.38 ftlb with a torque wrench.
Installing roof protection pads
Version 1: Roof protection pad PP 200/120-CL and PP 250/120-CL
The roof protection pads PP 200/120-CL and PP 250/120-CL are used for sensitive roof surfaces, e.g. mem-
branes, asphalt, etc. as well as for gravel roofs.
The roof protection pads are fitted as standard at the beginning and end of each base rail and in the area
of the rear supports. Depending on the ballast, additional roof protection pads are installed per rail.
Take the exact number and position of the roof protection pads from the AEROTOOL planning doc-
uments.
Positions PP 200/120-CL
less ballast
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
