SN
10
lo
n
g
si
d
e
Assembly
www.aerocompact.com
17
In order to avoid damage to the substrate, ensure that the roof protection pad
extends approx. 2 cm beyond the end of the base rail or that the transitions between the base rails are
covered.
Version 2: Roof protection pad PP 150/80
The roof protection pads PP150/80 are used for less sensitive roof surfaces, e.g. concrete roofs, etc.
Placement
The roof protection pads are fitted as standard at the beginning and end of each base rail and in the area
of the rear supports. Depending on the ballast, additional roof protection pads are installed per rail.
Take the exact number and position of the roof protection pads from the AEROTOOL planning doc-
uments.
Installing roof protection pads
Pull off the protective backing from the roof protection pad.
Place the roof protection pad underneath the base rail and adhere it in place.
Ensure that the tabs of the roof protection pad are completely enclosed by the profile.
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
