SN
10
lo
n
g
si
d
e
Assembly
www.aerocompact.com
19
Fix the ballast clamp:
Tighten the screw until the wings of the ballast clamp are flush with the ballast blocks.
Place the ballast blocks
.
Variant 2: Cross struts as ballast rail
The ballast rails can be mounted in the following positions:
behind the front support (under module)
in front of the back support (under module)
behind the back support
Take the exact number and position of the ballast rails and blocks from the Aerotool planning doc-
uments.
When ballast rails follow each other:
Lay out the ballast rails so that they overlap at the supports.
Hand tighten the ballast rails to the base rail.
Tighten the screws to 10 Nm or 7.38 ft lb with a torque wrench.
Lay out ballast blocks according to Aerotool planning documents.
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
