SN
10
p
lu
s
lo
n
g
si
d
e
Assembly
www.aerocompact.com
18
Installing roof protection pads
Pull off the protective backing from the roof protection pad.
Place the roof protection pad underneath the base rail and adhere it in place.
Ensure that the tabs of the roof protection pad are completely enclosed by the profile.
Place rail lines
Align the rail lines with the selected grid.
Install ballast
Depending on the circumstances, the system is ballasted differently.
Variation 1: Ballasting on the base rail
With this ballasting variation, the ballast blocks are mounted directly on the base rails. Up to 3 ballast blocks
can be fixed with one ballast clamp. The ballast blocks can be mounted in front and/or behind the back sup-
port.
Take the exact number and position of the ballast blocks from the AEROTOOL planning documents.
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
