TR
5
9
|
TR
74
Assembly
www.aerocompact.com
21
Mount further rows of modules
Continue placing the modules row by row.
Tighten the screws of all terminals with 15 Nm or 11 ft lb each.
Reposition / replace clamps
Demount clamp: Unscrew the screw at the clamp completely.
Depending on the mounting situation, squeeze the clamp laterally and pull it out or pull it laterally out of
the rail.
Bonding
For bonding, AEROCOMPACT provides the bonding wire clamp as an accessory (NOT
VALID IN THE USA). These are each mounted on the support rails.
Dependent on the mounting setting, each module row is bonded by the module clamps with grounding
pins.
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
