X
M
-P
Assembly
www.aerocompact.com
15
Fasten metal tile and support bracket
Insert the metal tile
and strike it against the roof batten with the back stop angle.
Hang the support bracket
.
Position the support bracket above the rafter
.
Make sure that the metal tile rests fully on the
support base.
When screwing, observe the minimum edge dis-
tance to the edges of the roof battens accord-
ing to ETA-11/0024.
For the screws, check/consider the minimum
requirement according to ETA-11/0024:
Screw diameter: min. 8 mm / 5/16 or 0.315 inch
Effective screw-in depth: min. 80 mm / 3 5/32 or
3.15 inch
Screw the metal tile set to the rafter with 2 wood
screws.
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
