X
M
-P
Assembly
www.aerocompact.com
21
Bonding
For bonding, AEROCOMPACT provides the bonding wire clamp as an accessory (NOT
VALID IN THE USA). These are each mounted on the support rails.
Depending on the installation, the module rows are connected to each other by the module clamps.
Exemplary representation
Bonding modules through module clamps
Bonding the individual module rows
Grounding the array by terminating to on-site ground
Attach the T-Bolt Assembly
to the rail.
Place the grounding wire
onto the rails.
Attach the clamp
and tighten with the nut.
Tighten the nut with 15 Nm or 11 ft lb.
Connect the wire
to the on-site ground.
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
