Page 55/79 – v2.9
5.6.
Using TOMBAK as a Voltage Level Converter
Presentation
The board can be used as a voltage level converter in every mode that used the PulseIn
signal as a reference signal. However, SYNC mode is a specific mode that gives extended
performance to the voltage converter feature (higher frequency, lower jitter,
lower insertion
delay
…).
An additional “Autofine delay” can be added which adds a 0-10ns delay while keeping a very
short insertion delay and ultra-low Jitter.
Timing diagram
Figure 12 : Pulse In detection signal with software adjustable threshold
Synoptic
Figure 13 : Main firmware features used in Voltage Level Converter
Summary of Contents for TOMBAK
Page 19: ...Page 19 79 v2 9...
