4
5. Cut out the covering on the top and
bottom surface of the wing as shown here.
Press down lightly on the center of the
cutout area to get a defined line to cut.
Ensure that you have a sharp razor blade to
give you a clean cut.
6. Assemble the collar as shown above and
place on the aileron bell-crank. Secure the
collar to the bell-crank from both the upper
hole with the 3x25mm screw and the bottom
hole with the 3mm set screw. Attach the
control connector to the flap control rod.
7. Detach the aileron from the wing and
remove the dowels from the hinge holes.
8. Insert the nylon pipe hinges into the
aileron. Cut 2 ridges off 4 pipe hinges for
the 2 outboard hinges on either aileron.
After satisfied with the placement of the
Summary of Contents for Beechcraft Baron G58
Page 1: ...1...
