AEROEL s.r.l. - PRADAMANO (UD) - ITALY
20
B2798_E 1.1, 2016-04-08
-
Measured value box
In the box it is shown the measured value and the directions about the vertical position and the alignment of the
product
No product in the measuring field
Indication of the vertical position of the product: the offset of the two parts of
the frame decreases to zero by placing the product in the vertical center of the
measuring range
Indication of over misalignment of the product (in the horizontal plane): the two
arrows appear in case of excessive misalignment of the product and invite to
rotate the instrument clockwise or counter-clockwise.
Diameter of the product properly positioned in the field of measurement
(trigger is not pressed)
Frozen diameter of the product (after trigger pressure)
PLEASE REFER TO CHAPTER 3.2 PRODUCT POSITIONING
-
Labels of the function keys
They indicate the menu or action that is obtained by pressing the respective function key from F1 to F4. In this
case, pressing F1 you enter the Setup menu of the instrument and pressing F3 in the Power off menu
2.13
SETUP MENU
From the measuring window, press the F1 key (Setup) to enter the setup
screen of the instrument.
The programming is done through menus consisting of a title (yellow field)
and a list of options.
Use the
arrow keys
(
F2
and
F3
) to navigate through the various options.
The selected row is highlighted in blue.
To select the option, press the
Enter key
(
F1
)
To exit or return to the previous level, press
Exit
(
F4
)
In the event that the options to be selected are not all shown in the window, on the right side the
a symbols
indicate the presence of other options in the list.
The initial menu contains the following options:
Measure Setup
Setting of some parameters about the measurement and display function
HWS.1 Setup
Basic instrument setup
Info
Hardware and software info
