24-Hour
Light
Water Low
Add Nutrients
Replace
Bulbs
Salad
Greens
Flowers
Vegetables
Live Plants
Herbs
When “Replace Bulbs” light on
control Panel
begins blinking after 6
months of use…
• Unplug AeroGarden 6 Elite+.
• Remove old
Grow Bulbs
and carefully discard.*
IMPorTAnT:
To avoid burning, be sure
Grow Bulbs
are cool before handling.
• Insert new
Grow Bulbs
into
Lamp Hood
.
• Plug in AeroGarden 6 Elite+ and press and release “Reset” button to
restart grow bulb timer.
Early
Grow Bulb
Replacement
If you replace
Grow Bulbs
before “Replace Bulbs” light illuminates, be sure to
restart grow bulb timer as follows:
• Press and hold “Lights” button until light next to your selected plant type
starts blinking – about 5 seconds.
• Release “Lights” button. The plant type selected light will continue to blink
for about 9 seconds. While plant light is still blinking…
• Quickly press and release “Reset” button. “Replace Bulbs” light will blink
once and the plant selected light will stop blinking.
Replace
Grow Bulbs –
order bulbs at www.aerogardensupport.com
12
*Check with local recycling authorities for
light bulb recycling availability in your area.
Basic Reminders About Your AeroGarden
(continued)
Raise
lamp Hood (lights)
As plants grow to
1-2” from lights
, raise
Lamp Arm
one notch at a time (each of the three
Lamp Arm
sections has
three notches). Be sure
Lamp Arm
is at the lowest setting when you start your AeroGarden 6 Elite+.
Unplug AeroGarden 6 Elite+ and remove
Bowl
from
Base
.
Raise
Lamp Arm/Lamp Hood:
• Hold
Lamp Arm
where it connects to
Lamp Hood
with
one hand. With other hand, push in
Locking Lever.
• Release
Locking Lever
while pulling up on
Lamp Arm.
•
Locking Lever
will automatically click into next
notch in the
Lamp Arm section.
Replace
Bowl
on
Base
and plug in
AeroGarden 6 Elite+.
Push
locking
lever
in
Push
locking
lever
in
1
2
3
Push
locking
lever
in
Push
locking
lever
in
