Remove & Save AeroGarden Water & Seed Pods
Skip this step if your AeroGarden is not planted and proceed to Step 2 on page 3.
Unplug your AeroGarden.
Remove
Bowl
from
Base
.
Remove
Grow Surface
and place in sink (or on towel) as
roots will drip water.
Pour water from
Bowl
into shallow dish to a depth of 1”.
Pour remaining water from
Bowl
into container that
holds at least 1 gallon and set aside.
Gently remove
Seed Pods
from
Grow Surface*
and place
plants upright in shallow dish. Be sure roots are in water.
A
B
C
Page 2
D
E
F
Grow Surface
(upside down)
AeroGarden Components
(continued)
*Use the illustration and corresponding numbered spaces to indicate where
Seed Pods
are located in the
Grow Surface Openings
so you can replace them in the same position later.
1.
2.
3.
4.
5.
6.
7.
Filter
Cover Plate
Pump
located
behind
Filter
Wire Slot
Pump Wire
Contact Strips
Pump Tower
Pump Connector
Grow Surface
Baking Dish
1 Gallon Container
Don’t worry if you tear a few roots or if the
Cross Beams
come out
with the roots.
Cross Beams
can easily be placed back in position
(see
Troubleshooting for instructions)
.
1
