Page 6
Reassemble Pump
With
Grow Surface
upside down, insert the
Pump
back into the
Pump Tower
making sure that:
• The
Rubber Feet
of the
Pump
are facing up.
• The
Face Plate
is facing toward you.
•
Pump
is securely seated in the tube in the
Pump Tower.
• The
Pump Wire
goes behind and underneath the
Pump,
and
lines up with
Wire Slot.
A
Insert
Cover Plate
in the
bottom of the
Pump Tower
and push down until all
corners snap in place.
Push
Pump Wire
back in
Wire Slot
.
B
Turn
Grow Surface
right side up and place clean or new
Filter
back
in slots in front of the
Pump
.
(If you do not have a Filter, please see
Troubleshooting on page 6.)
C
D
Replace
Grow Surface
in
Bowl
*.
Congratulations
!
Your AeroGarden is ready for its next planting!
* If you cleaned your
Pump
to reduce noise, fill the
Bowl
with water and plug in
your AeroGarden. If the
Pump
is still noisy, please contact Customer Service.
If you are working with a planted AeroGarden, skip
step E (below) and proceed to final steps on page 7.
E
5
